View Our Inventory


Description & Specifications

PRICE: Loaded on Truck, Our Warehouse, York, PA ………… $24,500.00

HMC Stock # 22170
Machine Serial No.: 44561-AT
Machine Model No.: 2516-20 x 144 Series 80 Dyna Shift
New Date: November 1960

Swing Over Bed Ways: 35"
Swing Over Cross Slide: 19-1/2"
Spindle Bore: 3-1/8"
Spindle Nose Type: D1-8 Camlock
Spindle Speeds: 40 to 1250 RPM
(48) Threads: 1/2 to 28 TPI
(48) Feeds: 0.0030" to 0.1683 TPR
Tailstock Quill Diameter: 5-3/4"
Tailstock Set Over: 1/2" Each Direction
Tailstock Quill Travel: 10"

Newall Model C80 Two-Axis Digital Readout System
Thread Chasing Dial
Hydraulic Speed Selecting and Shifting
Quick Change Tool Post with Assorted Tool Holders
Hydraulic Variable Speed Rapid Traverse to Carriage and Cross Slide
Inch Graduated Dials on Carriage, Cross Slide and Top Compound
Fixed Angle Top Compound for Tracer System – Non-Swiveling
Geared Hand Crank Tailstock Positioner
Bijur One Shot Lubrication System on Carriage and Tailstock
Chuck and Camlock Wrenches
(2) 14" Diameter Drive Plates with D8 Camlock Mount
(1) 13" Diameter Roller Type Steady Rest
(1) 18" Cushman 3 Jaw Chuck with 2 Piece Jaws and Hard Reversible Top Jaws, D8 Mount
(1) 21 Cushman 4 Jaw Chuck with 1 Piece Hard Reversible Jaws, D8 Mount
(1) #6 MT Dead Center in Headstock, is Removeable
(1) Non Removeable Live Center Built Into Tailstock Quill
(1) Large Boring Bar Tool Holder, 9" x 10" x 6-1/2" High with 3" Thru Hole
Full Length Chip Pan
Hardened and Ground Bed Ways in Good Condition
Built in Coolant Pump
Micrometer Carriage Stop
Air Gage Tracer System with Full Length Template Bar – PARTS MISSING
30 HP Main Motor, Wired for 3 Phase, 60 Hz, 208/230/460 Volts
Presently Wired for 440 Volt Operation

Overall Size: 273" (22.75') x 83" FB x 79" High x 24,000 Lbs.

This machine design has 3 main supporting sections, headstock end, mid machine and tailstock end. They are of cast iron construction with 2 jack screws on the front side and 2 jack screws on the rear side. On the tailstock end only, the rear half of the supporting pad is broken. We have the back piece. The previous owner tried to repair this but was not successful. The front half with the 2 jack screws is good and solid. We are not going to try and repair this. The machine has been test run in our shop and believed to be in good operating order.

Return to previous page

All sales are subject to our TERMS & CONDITIONS